✕
Our home designs
Custom solutions
Inspiration
Virtual tour
Our projects
Interior design
Who we are
Our story
Benefits
Get started
Steps
Budget planner
FAQ
Benefits
Contact
Contest
fr
|
en
Contact
fr
|
en
Models
Custom solutions
Inspiration
Virtual Tour
Our Projects
Interior Design
Get started
Budget Planner
Building Steps
FAQ
Specifications
Who we are
History
Benefits
☰
Specifications
We apply the best construction practices of the industry in a standardized manner.
The following technical specifications represent the standard for all our constructions.
Floors
Open web floor joists every 16 in.
Glued and nailed laminated LVL perimeter
Metal support posts in the basement
5/8-in. tongue and groove plywood glued and screwed to joists
Outside walls
9 7/8 in. thick to ensure a total R-value of 41.43*
Colonial-style vinyl siding
1 x 3 in. strapping, allowing outside air to circulate
Weather barrier
3/8-in. plywood
2 x 6 in. studs 16 in. on centre
Fiberglass insulation providing an R-value of 24
1 ½ inches insulation panels composed of a closed cell polyisocyanurate (polyiso) foam core, faced with laminate foil
1 x 3 in. strapping, allowing inside air to circulate and reflect heat.
1/2-in. screwed gypsum panels
Ceiling and roof
Insulation ensuring a total R-value of 62.92*
1/2-in. screwed gypsum panels
Continuous aluminum vapour barrier with sealed joints
3/8-in. plywood for superior strength
Approved roof trusses
Fiberglass insulation installed in two steps (R31 + R31)*
1/2-in. plywood on the roof
Type 3D asphalt shingles
Soffit and fascia (gutters not included)
Maximum roof ventilators
Electricity
Superior insulation of electrical sockets
Electrical copper wiring
200 amp electrical panel (Install on site by others)
Electrical outlet for ceiling lights in bedrooms
Outdoor lights
Smoke and carbon monoxide detectors
Electrical mast supplied and installed in factory
Light above the sink (kitchen) with independent switch
Light in the bathroom with independent switch
Range hood that evacuates air outside
Air exchanger with heat recovery (installed only with electric heat)
In-factory verification of the electrical system and of each circuit
Plumbing
Wide selection of faucets at the hardware store
Hot and cold water pipes up to joist level
Washing machine taps (optional)
Additional vent for future basement appliances
Toilet
One-piece acrylic tub
Pressure-balanced faucets
Stainless steel kitchen sink
ABS plastic drain up to joist level
In-factory verification of plumbing system
Finishing touches
Custom bathroom vanities
Custom kitchen cabinets
Wide selection of interior doors
PVC windows
Triple-glazed thermos Low-E argon
Low-E argon patio door
Edges of windows and doors sealed with polyurethane foam
Steel exterior door with vinyl frame